Polycom Manual Provisioning

The steps below will allow for the manual provisioning of a Polycom phone in the absence of automated provisioning.

Preparation

Before beginning the provisioning process, it is important to fulfill the configuration items below. This can be done via the Configuration>Extensions menu within Sharpen Admin.

Ensure the Polycom device is reset via this article. (Note the default password is 456)
Logged into Sharpen, navigate to Admin → Configuration → Extensions (Search the extension you wish to provision)
Gather the username, password, and server address of the extension that needs to be provisioned to the device.
1. (If your server address was listed as us1.vbx555.09.f.sipvbx.com on the extension page then you would enter us1.vbx555.sipvbx.com in the Server and Address fields.)
2. Example Username: 5758con1409, Example Password: fWAuHO1THprLLpV0EwWzpUyMxjYCT7cz, Example Server: us1.vbx23.sipvbx.com
Log into the Polycom device by navigating in the browser to https://xxx.xxx.xxx.xxx (ip address of the device)
Log in with the admin profile using the password 456
Navigate to “Simple Setup”
1. Under SIP server enter the server address and change the port to 5060.
2. Under Sip Line Identification Enter the display name as the agent’s full name
  1. Address and Authentication User ID enter the Username
  2. Authentication Password as the Password of the extension
  3. Lastly, name the label “x EXTEN”
Save those settings.
Navigate to (Settings → SIP)
Change the Local SIP Port under Local settings to 5060
Under “Outbound Proxy” set: Address → the server address from the Extension, Port → 5060, Transport → DNSnaptr
Under Server 1 set the following
1. Special Interop → Standard
2. Address → Extension Server Address (without the numbers and letters in the middle)
3. Port → 5060
4. Transport → DNSnaptr
5. Leave the rest default
Save these configurations
Reboot/Restart the phone and it should be provisioned (New Admin password will be 6311)