Versions Compared

Version Old Version 2 New Version 3
Changes made by

Brendon Newell

Brendon Newell

Saved on

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.

...

  1. Ensure the Polycom device is reset via this article. (Note the default password is 456)

  2. Logged into Sharpen, navigate to Admin → Configuration → Extensions (Search the extension you wish to provision)

  3. Gather the username, password, and server address of the extension that needs to be provisioned to the device.

    1. (If your server address was listed as us1.vbx555.09.f.sipvbx.com on the extension page then you would enter us1.vbx555.sipvbx.com in the Server and Address fields.)

    2. Example Username: 5758con1409,
      Example Password: fWAuHO1THprLLpV0EwWzpUyMxjYCT7cz,
      Example Server: us1.vbx23.sipvbx.com

  4. Log into the Polycom device by navigating in the browser to https://xxx.xxx.xxx.xxx (ip address of the device)

    1. If you’re having trouble finding the device's IP address, try looking in the following locations:

      • Local interface: Some devices will display the IP address is in the bottom-left corner of the Home Page screen (located physically on the phone).

      • Polycom phone menu: Using the menu browsing buttons on the device, the IP address can be found by navigating to Menu > Status > Network > TCP/IP Parameters.

  5. Log in with the admin profile using the password 456

  6. Navigate to “Simple Setup”

    1. Under SIP server enter the server address and change the port to 5060.

    2. Under Sip Line Identification Enter the display name as the agent’s full name

      1. Address and Authentication User ID enter the Username

      2. Authentication Password as the Password of the extension

      3. Lastly, name the label “x EXTEN”

  7. Save those settings.

  8. Navigate to (Settings → SIP)

  9. Change the Local SIP Port under Local settings to 5060

  10. Under “Outbound Proxy” set: Address → the server address from the Extension, Port → 5060, Transport → DNSnaptr

  11. Under Server 1 set the following

    1. Special Interop → Standard

    2. Address → Extension Server Address (without the numbers and letters in the middlesaved from step 3a in the document, it should look something like us1.vbx###.sipvbx.com - you’ll leave out any stray numbers or characters between the vbx### server number and sipvbx.com text)

    3. Port → 5060

    4. Transport → DNSnaptr

    5. Leave the rest default

  12. Save these configurations

  13. Reboot/Restart the phone and it should be provisioned (New Admin password will be 6311)